Jupiter 2 RESIN VAT

Description

Original metal resin tank for the ELEGOO Jupiter 2 resin 3D printer, with the PFA release film already installed, so it is ready to use as soon as it is fitted.

Why replace your resin tank?

The release film at the bottom of the tank is a wear part: it is stressed by every layer that peels off, and resin and repeated cleaning wear it down. Change it, or the whole tank, if you notice:

• cloudy, scratched, punctured or stretched film;
• resin leaking, or prints that stick to the film instead of the build plate;
• layers that fail in the same area again and again, or a worn tank after many prints.

Key features

• Made for the Jupiter 2 — the original tank of the printer, so it fits exactly.
• PFA release film pre-installed — no film to cut or stretch, ready out of the box.
• Smart heating — keeps the resin at a steady 30 °C, for good fluidity, adhesion and a higher print success rate.
• Aluminium alloy body — solid and durable for long-term use, fewer replacements.
• Quick-lock film change — the film is changed without tools or screws: snap, lock and print again with no downtime.
• Works with a wide range of resins, so you stay free to choose the material for each job.

Compatibility

For the ELEGOO Jupiter 2 only. It is not interchangeable with the Jupiter, Jupiter SE, Saturn or Mars series tanks. If you are not sure of your model, contact us before ordering.

Good to know

• Before fitting, empty and clean the printer’s vat area and wear gloves when handling resin.
• Never scrape the film with metal tools; use a plastic spatula only.
• Filter the resin when you pour it back, to keep small cured pieces from damaging the new film.